Panorama Antennas GPS25 Series Installation Instructions page 2

5. Magnetic Mounting
Check that the vehicle has a steel roof as the mount will not work on plastic or alloy bodies. The mount has a scratch resistant pad which is suitable for
direct contact with the roof. No other material should be placed under the antenna base as this will reduce the magnetic adhesion. Make sure that the
selected mounting surface is clean and dry before placing the antenna in position.
IMPORTANT: Never attempt to detach, reposition or transport the antenna using only the cable as this may damage the cable connection.
6. Routing and terminating coaxial cables
Route the coaxial cable to the equipment, ensuring that the cable is secured and protected from subsequent damage during access. The cable should be
routed observing the minimum bend radius of 13mm (1/2"). If cable ties are used, they should not be overtightened, as this could distort the cable profile
and affect the antenna performance.
7. Commission and Test
● Check the GPS cable with DC to measure high resistance.
● Connect the GPS cable to the GPS receiver and check for satellite acquisition.
8. Notices
DO NOT
• operate the equipment in an explosive atmosphere.
• attempt to install the antennas without the proper safe equipment to access the install location.
• install the antenna in such a way that it may fall and cause injury.
• chew parts or put them in mouth, keep away from unsupervised children.
European Waste Electronic Equipment Directive 2002/96/EC
Waste electrical products should not be disposed of with household waste. All electronic products with the WEEE logo must be
collected and sent to approved operators for safe disposal or recycling. Please recycle where facilities exist. Many electrical/electronic
equipment retailers facilitate "Distributor Take-Back scheme"for household WEEE. Check with your Local Authority or electronic
retailers for designated collection facilities where WEEE can be disposed of for free.
Waiver: This document represents information compiled to the best of our present knowledge. It is not intended to as a representation or warranty of fitness of the products described for any particular pur-
pose. This document details guidelines for general information purposes only. Always seek specialist advice when planning installations and ensure that antennas are always installed by a properly qualified
installer in compliance with local laws and regulations.