MD SPORTS 18402 Assembly Instructions Manual page 13

FIG.9 PUSHER ASSEMBLY
28. Tear off the backside paper of the Hockey Felts (#25) and stick them at the bottom of the Hockey Pushers (#24).
FIG.9
ELECTRONIC SCORER OPERATION
1. Press the "MAIN POWER" switch, and then press the "SCORER BOARD POWER" button.
You will hear music and the scores 0-9 will automatically show on the scoreboard.
2. There is a pre-set period of 15 minutes which can be adjusted to 10 minutes, 5 minutes, or
"No Time Limit" mode by pressing the "MINUTES" button.
3. Press the "RESET" button to begin the game.
4. After a game is finished while the table is still on, press the "RESET" and the scoreboard will
clear all scores to 0. The time will be shown according to the time mode previously selected.
5. When the score reaches 99 points, the indicator will show "00" on the scoreboard. Cheering
sounds will be produced. Time will revert to the mode of the last game. The score will not
change, and the game ends. No additional points will then be counted for any puck that enters
the goal box.
NOTE: The scoreboard will turn itself off automatically if it is not used for 20 minutes. We
suggest to turn the power off when the game will not be used for an extended period of time.
However, do not turn the power off when playing in the "No Time Limit" mode.
This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
THERMAL PROTECTOR
MOTOR
SCHEMATIC DIAGRAM
CONNECTOR
ON/OFF SWITCH
YOU ARE NOW READY TO PLAY
12
SPT-2 POWER CORD
AC 100-125V
POLARIZED PLUG