Table of Contents
Advertisement
PREPARING THE CAMERA
Preparing Power Supply
Always turn off the camera's power before changing power supply.
Loading Batteries
To load the batteries into the camera:
1. Open the battery cover.
2. Load batteries in the battery compartment.
Make sure they are loaded in their polarity as
shown inside the battery compartment.
3. Close the battery door. Make sure that the battery cover
is firmly closed.
Note:
It is recommended to use either two AA size Ni-MH rechargeable or one CR-V3 for
battery power supply.
If you are not going to be using the camera for an extended period of time, you should
remove the batteries to prevent leaks or corrosion.
Do not use a mix of different types, manufactures, classification of batteries.
Low temperatures (under 0 ) may reduce the output efficiency of batteries, thereby
shortening the operation time of camera.
Using the Power Adapter (Optional Accessory)
1. Open the terminal cover and connect one
end of the power adapter to the adapter port
(DC IN 3.4V) as illustrated.
2. Connect the end of the power adapter to
a power outlet.
Note:
Only use the AC adapter specified for this camera. Use of any other power source may
cause damage to the camera and possibly start a fire.
The AC power adapter is an optional accessory which may (or may not) be included with
your camera kit depending upon the retail bundling options specified by your camera
dealer.
Grasp the adapter, not the cord, when unplugging the adapter from a wall socket.
If the power cord becomes damaged (exposed or severed wires, etc.), please purchase
a new AC adapter. Use of a damaged cord may cause fire or electrical shock.
Switch off and disconnect the camera from the AC adapter before unplugging it from the
wall socket.
85939-450-E.p65
o
11
11
2002/11/12, ¤U¤È 01:13
Advertisement
Table of Contents
