Table of Contents
Advertisement
The „ME“-data sheet contains additional information for InMax actuators
of the size „S“, for the optimization and simplification in regard to
planning, installation and initial start up. It provides influences of
external factors in reference to the safe initiation of the actuators.
In particular it represents the installation, as well as different dampers,
fire protection dampers and armatures. Additionally describing different
accessory elements and their mounting to the actuator.
Dimension in mm
60
incl. radius
of bend for
the cable
All InMax actuators are equipped with a 10 position switch a push button and a multicolor
LED for calibration. These control elements are to be found cable-laterally behind the two
middle sectioned dummy plugs. For operation these must be removed. The calibration can
be achieved despide lining up tension at the actuator. It has to be of great concern that
the dummy plugs must be rescrewed in order to comply with the IP-protection class. The
operation of the switch and button has to be done by means of a small screwdriver. Force
with strong pressure and /or rotation is to be avoided in any case, since otherwise control
electronics can be damaged irreparably. By bad visibilities a flashlight should be used.
Attitudes of torque and running time can be achieved also before mounting. The adjustment
of angle of rotation can be started only with an outside load and accurate mounting.
When mounting actuator outdoors it has to be certain that the actuator is protected against
direct sun exposure (heat and UV), rain and snow by employing an enclosure roof. Supply
voltage is to be applied immediately after mounting in order to assure integrated heating
at start. Since explosion proof actuators must have internal safety temperature limiters,
these may not be exposed neither at storage nor during operation to a too high temperature.
Otherwise the limiters could respond and switch of the actuator irreversibly.
Germany, Mühlsteig 45, Gewerbegebiet Süd 5, 90579 Langenzenn, Tel. +49 (0)9101 9081-0, Fax +49 (0)9101 9081-77, E-Mail info-de@schischek.com
Side R
Side L
210
E X P L O S I O N P R O O F
Dimension, drill template
u
Control elements: switch – push button – LED
u
Outdoor installation
u
Mounting using form-fitting shaft connection (square shaft)
u
Mounting using clamp mounting (round shaft)
u
Mounting on butterfly valves and ball valves
u
Mounting InSwitch
u
118,5
6 × Ø 4,4
6 × M 4
Double sqaured 12 × 12 mm
10-position switch (S)
Push button (T)
3-colour LED
30
30
14
RST
Advertisement
Table of Contents
