Advertisement
Specifications
Setup - Before use:
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
Make sure that the On/OFF Switch is in the off-position and remove the Battery pack before performing
any procedure in this section.
installing / a djusting the Wheel Guard
The Outer Wheel Guard is attached to the Inner
Wheel Guard to form the Wheel Guard Assembly
for cutting. Assemble the wheel guard as follows:
1. Place the Outer Wheel Guard over
the Inner Wheel Guard.
2. Press the Outer Guard onto the Inner
Guard until it snaps into place.
3. Make sure the clips on each end of the Outer
Guard are securely attached to the Inner Guard.
4. Rotate the Wheel Guard Assembly as needed
to shield you during the planned work.
Page 8
Battery Type
Charger Type
No Load Speed
Arbor Hole Diameter
Cut‑Off Wheel Diameter
Min – M ax Wheel Thickness 0.030"– 0 .125"
tO preVent SeriOuS inJury: Do not operate this tool without the
Wheel Guard properly installed.
For technical questions, please call 1-888-866-5797.
Bauer 20V Li‑ion:
57007 (sold separately)
Bauer 20V Li‑ion:
57006 (sold separately)
n:19,000/min
3/8"
3" (Ø 7 6 m m)
inner Wheel Guard
clips
Wheel Guard
assembly
Item 59365
Outer
Wheel
Guard
Advertisement
