Rinse Aid; Setting The Amount Of Rinse Aid - Bosch 300 Series Use And Care Manual

¡ The water hardness is 0 - 8 °E.
You can omit special salt.
Press
1.
To open the basic settings,
2.
press
a The display shows Hxx.
a The display shows
Press repeatedly until the
3.
display shows H00.
To save the settings, press
4.
for 3 seconds.
a The water softening system is
switched off and the salt refill
indicator is deactivated.
Rinse aid system 10 Rinse aid system
Rinse aid system
10.1 Rinse aid
For optimum drying results, use

rinse aid.

Only use rinse aid intended for
household dishwashers.
Adding rinse aid
If the rinse aid refill indicator lights
up, fill the dispenser with rinse
aid. Only use rinse aid intended
for household dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
lift ⁠ .
⁠ .
for 3 seconds.
⁠ .
and
2
1
Rinse aid system en-us
Add rinse aid up to the max
2.
mark.
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the
wash cycle.
Close the lid of the dispenser
4.
for rinse aid.
a The lid clicks into position.
10.2 Setting the amount
of rinse aid
If there are streaks or water spots
on dishware, change the amount
of rinse aid.
Press
1.
To open the basic settings,
2.
press
a The display shows Hxx.
a The display shows
Press
3.
til the display shows the value
set at the factory r05.
Press repeatedly until the
4.
right amount of rinse aid has
been set.
– A low setting adds less rinse
aid during the wash cycle
and reduces streaking on
dishware.
– A higher setting adds more
rinse aid during the wash cy-
cle, reduces water spots and
improves the drying result.
To save the settings, press
5.
for 3 seconds.
max
⁠ .
for 3 seconds.
⁠ .
repeatedly un-
21