DeWalt DW089 User Manual page 26

DW 089/ D W089CG
Magnets
E
The magnets (t) allow the detector to be mounted to the metal tracks
during the installation of a suspended ceiling.
DETECTOR OPERATION (FIG. 9)
1. Set up and position the laser.
2. Turn the detector on by pressing the power button (q).
3. Position the detector so that the sensor window (u) is facing
4. Use the marking notches (p) to accurately mark the position of the
MOUNTING ON A GRADE ROD (FIG. 9, 10)
1. To secure your detector to a grade rod, first attach the detector to
24
DW089_DW089CG - User Manual - NA - May 2018.indd 24
the laser beam. Move the detector up or down within the
approximate area of the beam, until you have centred the
detector. For information about the display window indicators
and the audible signal indicators, refer to the table titled
Indicators.
Above
Grade
fast
beep
laser beam.
the clamp by pushing in on the clamp latch (v). Slide the tracks (w)
on the clamp around the rail (x) on the detector until the latch (y) on
the clamp pops into the latch hole (z) on the detector.
INDICATORS
Slightly Above On
Grade Grade
fast steady
beep tone
Slightly Below Below
Grade Grade
slow slow
beep beep
5/25/2018 10:40:49 AM