Table of Contents
Advertisement
Contact Grill
CG14G-2TP
Product cook times and platen set point temperatures can be adjusted in
programming mode. While in programming mode, if no button is pressed
for a period of 15 seconds, the unit will automatically exit programming
mode and return to normal operation.
NOTE: Set point temperatures for both right and left side products are
programmed ONLY from the left display (i.e., setting the temperature for
product 2 on the left display will also be the temperature for product 2 on
the right display).
Product Programming — Left Side
A. For approximately 1 second, press and hold the TEMP button on the
left display while at the same time pressing the product button to
program (see Figure 1). The display window will show "- - - -". Enter the
password 4,3,2,1 (password numbers will not appear on the display).
The display window will then show the current preset cook time and the
selected product LED will flash.
B. Press the UP(1) and DOWN(2) arrow buttons to adjust the cook time.
C. Press the TEMP button to save the new cook time value (see Figure
2). Afterwards, the current set point temperature will be displayed.
D. Press the UP(1) or DOWN(2) arrow button to adjust the temperature.
E. Press the TEMP button to save the setting.
F. Programming of this product is complete. Press the TEMP button
again to exit programming mode or repeat steps B through E to make
additional changes to this product.
Product Programming — Right Side (time only)
A. For approximately 1 second, press and hold the TEMP button on the
right display while at the same time pressing the product button to
program. The display window will show "- - - -". Enter the password
4,3,2,1 (password numbers will not appear on the display). The display
window will then show the current preset cook time and the selected
product LED will flash.
B. Press the UP(1) and DOWN(2) arrow buttons to adjust the cook time.
C. Press the TEMP button to save the setting.
D. Programming of this product is complete. Press the TEMP button
again to exit programming mode or repeat steps B through C to make
additional changes to this product.
Resetting to Factory Defaults
To revert all settings back to the original factory defaults:
A. Turn the unit off.
B. Press and hold both the TEMP button and the "3" button.
C. Turn the unit back on and wait 5 seconds.
D. Release the TEMP button and the "3" button.
NOTE: All previously saved settings are lost upon resetting the defaults!
Use with caution.
Printed in USA 09/06 © 2011
Programming Instructions
Figure 1
Figure 2
4
P
C
LLC
RINCE
ASTLE
W O R L D W I D E
CG14G-2TPrev--_EN
Advertisement
Table of Contents
