• Save carton and packaging materials for inspection purposes. • Contact Prince Castle Customer Sales Department at 1-800-323-2930 to arrange for a replacement to be sent. 2. Verify that all parts have been received. 3. Insert the power cord into proper receptacle.
small adjusting screw will be exposed. Using a small 7. When buzzer sounds and the done light comes on, screwdriver and a stop watch or clock with a immediately push handle back to release crowns from second hand, turn the screw clockwise to increase heating platen.
7 bottom terminals. See figure . 2. Disconnect green/yellow ground wire from the power switch. 3. For Model 212-G/212-GF disconnect brown wire from the power switch (B). For Model 212-GH disconnect brown and black wires from the power switch.
Page 5
Tools Required Flatblade screwdriver ing procedure. Make sure to coat new thermostat bulb with thermo-coat provided. 1. Remove screw holding buzzer to faceplate. 2. Cut wires A and B and strip wires 1/4’. HOW TO CALIBRATE TEMPERATURES 3. Replace inoperable buzzer. 4.
Page 6
7. Position retaining ring on new switch 1/4î (6 mm) REPLACE TIMER (See figure 13.) from end of bushing. See figure 11. figure 13 figure 11 RETAINING NUT 1/4î (6 mm) SWITCH BODY 1 mm INSULATOR ELECTRICAL BOX RETAINING RING CAUTION: Be sure insulator is between switch body and retaining ring.
TROUBLESHOOTING CHART Problem Cause Solution 1.Power Light Off. Circuit Breaker Off. Check and Reset. Unit Not Plugged In. Plug In Cord. Power Switch Off. Turn To On Position. Inoperable Power Switch. Replace Power Switch. Loose Wires. Check All Wire Connections. Inoperable Power Light.
WIRING DIAGRAM IMPORTANT ELECTRICAL INFORMATION This unit’s power cord has International colored wires, which are different from Domestic. Blue Neutral Brown Green/Yellow Ground Black...
Need help?
Do you have a question about the 212-G and is the answer not in the manual?
Questions and answers