Operation Mode; Important Safety Information; Fixing Instructions; Installation - BorMann BLF2150 Instructions Manual

E N
I. Operation mode
50W, 100W, 200W, 300W, 400 W:
•
The solar charging time is 5-8 hours, but there are many factors to be considered, such as the location and temperature of the area.
• When discharging, the mode is :100% brightness in the first hour, 80% brightness in the second hour, 60% brightness in the third hour, 50% brightness in the
fourth hour, 30% brightness in the fifth to sixth hour. It will remain on until dawn where it will go into charging mode.
• Οperating time: 3H, 5H , 8H
• Another mode is brightness adjustment mode, which is indicated on remote control
• For best results, it is recommended to use the automatic mode "AUTO".
• Usually when the device is switched on, the automatic mode is selected by default.
• Automatic mode: The brightness of the whole lamp can be adaptively controlled according to the battery's own power
II. IMPORTANT SAFETY INFORMATION
• Do not dispose the battery in fire. This may result in an explosion.
• Do not expose the light to fire or intense heat as the battery may explode.
• Do not immerse in water.
• Never look directly into the light or shine it into another person's eyes
• Consult your local construction guide, if needed, for installing the light fixture in the building.
III. FIXING INSTRUCTIONS
• The light fixture should be installed on a flat and stable surface
• Avoid installing the light near an air conditioner, a central heater, or high voltage system
• The solar charger board should be set in a sunny area where maximum sunlight can be collected. Typically, the solar board
should face a direction (south) where sunlight can charge the board for at least 3 hours per day (5 hours per day if behind glass)
It is suggested to charge the light for 24 hours before first use
• Use a soft wet cloth to periodically (at least once a year) clean the charger board to avoid the reduction of power output due to
accumulated dust
IV. INSTALLATION
1-Fix the bracket of the solar panel.
4-Adjust the angle which you need.
2
1 Solar Panel
2 Aluminium Alloy
3 Tempered glass
4 Ventilation
5 Outlet
6 Remote Control
2-Remove the bracket from the lamp body and fix it.
5-Connect the wire of the solar panel to the wire
of the lamp.
4
5
6
WWW.NIKOLAOUTOOLS.GR
1
2
3
3-Fix the lamp body to the bracket.