Adjusting The Motion-Control Damper; Adjusting The Motion-Control Neutral-Lock Pivot - Toro Z Master 75990 Operator's Manual

Adjusting the
Motion-Control Damper
The top damper mounting bolt can be adjusted to
obtain a more desired motion-control lever resistance.
See Figure 84 for mounting options.
Figure 84
Right-hand motion control shown
1. Torque the locknut to 23 N∙m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Adjusting the
Motion-Control
Neutral-Lock Pivot
The flanged nut can be adjusted to obtain a more
desired motion-control lever resistance when moving
it to the neutral-lock position. See
adjustment options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired
feel.
For more resistance, tighten the flanged nut.
For less resistance, loosen the flanged nut
3. Tighten the jam nut.
g008620
1. Flanged nut
58
Figure 85
Figure 85
2. Jam nut
for
g008621