Alarms And Error Messages; Alarm Mode - NEWERA Pump Systems Syringe HEATER-KIT-1LG Complete User's Manual

New Era Pump Systems Inc.
CAL H nnn
Finalize the heating pad calibration.
4)
• The calibration entry process can be repeated before the process is finalized, or the entries can be
ignored if the process is not finalized. Turning off power will discard the entries.
• To finalize the calibration, enter the command:
CAL
• If the calibration data was valid, the heater will respond with:
OK
• If there was an error in the calibration, the heater will respond with:
?NA
Performing a system reset will reset the calibration to the factory defaults.

Alarms and Error Messages

8.
8.1

Alarm Mode

Alarm Mode is set when the measured temperature reaches the alarm level, 20 C (36 F) above the Set
Point. The heater will exit Active Mode, turning the "Active" LED off, the red "Alarm" LED on, and the
display will flash the alarm message:
is exited, turning the "Alarm" LED off, when the measured temperature reduces below the alarm level, or
the Set Point is raised above the alarm level.
8.2
Error Messages
Indicates a system fault, where 'n' is the fault code. The heater will exit Active Mode, turning the "Active"
LED off, the red "Alarm" LED on, and the error message will be displayed. The fault codes indicated by
'n' are:
n Description
1 Heater pad sensor differential
2 Control box internal temperature
3 Heater pad sensor minimum temperature
Publication #1200-01
www.SyringeHeater.com
Pressing any key will clear the message. Alarm Mode
n
8
Model HEATER-KIT-1
12/25/20