Immergas HYDRO 3 V2 User Manual page 66

4.6.4 OPERATING MODES.
On/Off Operations
1) Press to start the indoor unit:
2) Press again to stop the operation of the indoor unit.
When the unit is off, the modes are visible on the display.
Mode and temperature.
1) Press . Display screen shows the operating mode:
2) Press each time to change the operating mode accord-
ing to the order shown below:
Cool
Dry
3) In Cooling and Heating mode, press
temperature setting. Press
ture by 1°C (default). Long press to change the temperature
continuously.
Note:
• Temperature setting cannot be adjusted in the Ventilation
and Dehumidification mode.
30
31
Heat
Fan
and to adjust the
and to adjust the tempera-
Fan speed.
Every time when you press the
changed in the following order:
1) 3 speeds: the fan speed will be adjusted in turn as shown
below:
Auto Low
Note:
• The fan speed set on the remote controller should match
with the air conditioner. For how to set the fan speed, see
section "Initial Settings".
Vertical swing.
1) When the unit is on press
function: will light up and the signal is sent to the indoor
unit.
2) When the vertical swing is on, press
function.
Note:
• When the unit is turned off, the button is invalid.
• Each time the vertical swing signal is sent, the icon keeps
lighting up for 15 seconds and then disappears. The indoor
unit remains vertical swing operation.
66
button, fan speed is
32
Mid High
to start the vertical swing
33
to turn off this