Advertisement
7. Trouble Shooting
Having trouble?
Noise is louder than specifications.
Nothing appears in the wireless remote controller display, the display
is faint, or signals are not received by the indoor unit unless the remote
controller is close.
The operation lamp near the receiver for the wireless remote controller
on the indoor unit is flashing.
The wireless remote controller does not operate (the indoor unit beeps
4 times).
8. Specifications
Item
Power source
Height
Width
Dimension
Depth
Net weight*
2
Airflow rate (Low-Middle-High)
Fan
External static pressure*
Sound level (Low-Mid-High)*
4
Filter
Item
Power source
Height
Width
Dimension
Depth
Net weight*
2
Airflow rate (Low-Middle-High)
Fan
External static pressure*
Sound level (Low-Mid-High)*
4
Filter
Notes:
*
O peration temperature of indoor unit.
Cooling mode: 15 °C WB - 24 °C WB
Heating mode: 15 °C DB - 27 °C DB
*1 C ooling/Heating capacity indicates the maximum value at operation under the following condition.
Cooling:Indoor: 27 °C DB/19 °C
Heating:Indoor: 20 °C DB
*2 The value in the parenthesis are for the PEAD-M•JAAD model.
*3 The external static pressure is set to 50 Pa at factory shipment.
*4 The operating noise is the data that was obtained in an anechoic room.
Model
PEAD-M50JAA(D)
mm
mm
900
mm
kg
26(27)
m
/min
12.0-14.5-17.0
3
Pa
35/50/70/100/125
3
dB(A)
30-35-39
Model
PEAD-M125JAA(D)
mm
mm
1400
mm
kg
39(40)
m
/min
29.5-35.5-42.0
3
Pa
35/50/70/100/125
3
dB(A)
36-40-44
WB Outdoor: 35 °C DB
Outdoor: 7 °C DB/6 °C WB
Here is the solution. (Unit is operating normally.)
■The indoor operation sound level is affected by the acoustics of the
particular room as shown in the following table and will be higher than
the noise specification, which was measured in an echo-free room.
High sound-
Broadcasting
Location
studio, music
examples
Noise levels
■The batteries are low.
Replace the batteries and press the Reset button.
■If nothing appears even after the batteries are replaced, make sure that
the batteries are installed in the correct directions (+, –).
■The self diagnosis function has operated to protect the air conditioner.
■Do not attempt to repair this equipment by yourself.
Turn off the power switch immediately and consult your dealer. Be sure
to provide the dealer with the model name.
■Switch the auto mode setting to the AUTO (single set point) mode or
AUTO (dual set point) mode. For details, refer to the included Notice (A5
sheet) or the Installation Manual.
PEAD-M60JAA(D)
220-240 V (50/60 Hz)
29(30)
14.5-18.0-21.0
35/50/70/100/125
30-33-37
Standard filter
PEAD-M140JAA(D)
220-240 V (50/60 Hz)
250
1600
732
43(44)
32.0-39.0-46.0
35/50/70/100/125
40-44-49
Standard filter
absorbing
Normal rooms
rooms
Reception
room, hotel
room, etc.
lobby, etc.
3 to 7 dB
6 to 10 dB
PEAD-M71JAA(D)
PEAD-M100JAA(D)
250
1100
732
17.5-21.0-25.0
24.0-29.0-34.0
35/50/70/100/125
35/50/70/100/125
30-34-39
Low sound-
absorbing
rooms
Office, hotel
room
9 to 13 dB
1400
38(39)
33-38-42
11
Advertisement
