Table of Contents
Advertisement
• Connect the supply hose assembly (
• Connect the return hose assembly (
Step 5.
Turn on the flow of water to the heat exchanger, and let it run for several minutes.
Step 6.
Attach the air-purging tool to the air-purging valve at the top of the heat exchanger, and place the
drain end into a 2-liter (or larger) container to catch the water and air bubbles that escape during
the filling procedure.
Figure 62. Installing the air-purging tool
Step 7.
When there is a steady stream of liquid into the container from the air-purging tool, disconnect the
tool from the heat exchanger.
Attention: If water drips from the air-purging valve after you remove the air-purging tool, reattach
the tool and disconnect it again to seal the valve.
56
ThinkSystem Rear Door Heat eXchanger V2 User Guide
1
) to the supply manifold-coupling (
3
) to the return manifold-coupling (
2
).
4
).
Advertisement
Table of Contents
