Advertisement
Frequency Range MHz
2402-2480
2412-2472
5150-5250
5250-5350
5470-5725
5725-5850
RF Radiation Exposure Statement
This equipment complies with RF radiation exposure limits. This
equipment should be installed and operated with a minimum
distance of 13.78 inches (35 cm) between the radiator and your body
for 2.4 GHz and 5 GHz operations. This transmitter must not be co-
located or operating in conjunction with any other antenna or
transmitter.
Mexico
La operación de este equipo está sujeta a las siguientes dos
condiciones: (1) es posible que este equipo o dispositivo no cause
interferencia perjudicial y (2) este equipo o dispositivo debe aceptar
cualquier interferencia, incluyendo la que pueda causar su operación
no deseada.
Ukraine
Hereby, Hewlett Packard Enterprise Company declares that the radio
equipment type [The Regulatory Model Number [RMN] for this
device can be found on page 1 of this document] is in compliance
with Ukrainian Technical Regulation on Radio Equipment, approved
by resolution of the CABINET OF MINISTERS OF UKRAINE dated May
24, 2017, No. 355. The full text of the UA declaration of conformity is
available at the following internet address:
certificates.ext.hpe.com/public/certificates.html
United States
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit that is different
from that to which the receiver is connected.
Consult the dealer or an experienced radio or television
technician for help.
Improper termination of access points installed in the United States
configured to a non-US model controller is a violation of the FCC
grant of equipment authorization. Any such willful or intentional
violation may result in a requirement by the FCC for immediate
termination of operation and may be subject to forfeiture (47 CFR
1.80).
For additional safety and regulatory information about this product,
2
Max EIRP
9 dBm
20 dBm
23 dBm
23 dBm
30 dBm
14 dBm
https://
refer to the Aruba AP-375ATEX Series Access Points Installation Guide
Hazardous Location Operation
Class I Division 2, Groups A, B, C and D,T4
Class I Zone 2, Group IIC, T4
Ambient Temperature -40 °C to +65 °C
IP 66
Explosion hazard. Do not remove or replace while
circuit is live unless the area is free of ignitable
concentrations.
!
Avertissement: Risque D'Explosion. Ne pas débrancher
tant que le circuit est électrifié sauf si il n'y a aucune
concentration de vapeurs combustible.
Do not use the USB connector in a hazardous area.
!
Avertissement: Ne pas utiliser de connecteur usb dans
les environnements dangereux.
ATEX Marking
ATEX Cert Number: ITS20ATEX305966X
WARNING – DO NOT OPEN WHEN AN EXPLOSIVE ATMOSPHERE IS
PRESENT
WARNING – DO NOT CONNECT OR DISCONNECT WHEN
ENERGIZED
WARNING – POTENTIAL ELECTROSTATIC CHARGING HAZARD –
SEE INSTRUCTIONS
.
Advertisement
