Related Manuals for Seura SW-2
Summary of Contents for Seura SW-2
- Page 1 WARRANTY REGISTRATION REGISTER FOR EXTRA BENEFITS Activate within 30 days of purchase: seura.com/activate " OUTDOOR TV SLIM WALL MOUNT 25mm 1" INSTALLATION GUIDE Model Number: SW-2...
- Page 2 Compatible with Séura Outdoor TVs: Pair with any Séura Outdoor TV 42″ – 86″ or any other compatible display not surpassing a maximum weight limit of 220 lbs. Compatible with VESA mount patterns up to 600×400. Safety Prior to the installation of this product, read all •...
-
Page 3: Parts Included
Parts Included Before using the device, please check the following contents of the box for completeness. Illustrations are not to scale. If any parts are missing or damaged, contact Séura. Mounting Plate Wall Mounting Template (located on inside bottom of box) (2) Slim Mount TV Brackets Mounting Tools and Hardware... -
Page 4: Installation Tools
P5080T Parts and Tools Required (not included) Installation Tools The following tools may be required depending on your particular installation. They are not included. The following tools may be required depending upon your particular ¼˝ Drill Bit for ˝ Electronic Stud Finder Wood Stud Pencil Level... - Page 5 Features Top Leveling Screws Allows for leveling adjustments of the TV after mounting Mounting Slots Allows for a variety of stud Directional configurations Mounting and lateral shift Arrows adjustments when mounting Lets you know your TV which edge is up Cable/Electrical Cut Out Large center cut out is convenient for power and...
-
Page 6: Installation
IMPORTANT: HANDLE THE TV IN A VERTICAL POSITION TO AVOID DAMAGE TO THE SCREEN. IF PLACING THE TV SCREEN-SIDE DOWN OR LEANING AGAINST A WALL DURING INSTALLATION, COVER THE SCREEN WITH A PROTECTIVE CLOTH OR BLANKET. Installation IMPORTANT: THIS PRODUCT MUST BE MOUNTED TO CONCRETE, STONE, BRICK OR WOOD STUDS. The wall must be able to support five times the weight of the television and the mount combined. - Page 7 3. Drill pilot holes Pre-drill the four marked holes on the wall 3-inches deep with a 7/32″ drill bit. 4. Attach mounting plate Make sure the arrows on the mounting plate point up. Align the mounting plate with the pre-drilled holes.
- Page 8 Concrete, stone or brick wall mounting: See page 6 for mounting to a wood stud wall 1. Choose mounting location If mounting a Séura Outdoor TV, reference page 14 for measurements from the edges of the TV to the edges of the mounting template to properly place the template in the desired location on the wall.
- Page 9 3. Drill pilot holes Pre-drill the four marked holes on the wall 3-inches deep with a 7/16″ masonry drill bit. Insert a plastic anchor into each of these holes. If necessary, lightly tap each anchor into place with a hammer. 4.
- Page 10 Step 2: Attach Slim Mount TV Brackets to TV If installing with a soundbar or if the TV’s VESA screws are not long IMPORTANT: Check your TV manual before attaching mount brackets enough to attach the Slim Mount to TV. Some models require attaching soundbar brackets in tandem TV Brackets, then use the four with attaching mount brackets.
- Page 11 Step 3: Hang the TV IMPORTANT: NEVER TRY TO HANG A TV BY YOURSELF. ALWAYS USE AT LEAST TWO PEOPLE TO LIFT THE TV INTO PLACE. 1. Lift the TV and bring the back of the TV towards Do not let go of the TV until you are certain that the the wall, positioning it slightly above the mounting top and bottom hooks of both mounting brackets plate.
-
Page 12: Step 4: Adjust The Tv
Step 4: Adjust the TV Caution: It is possible to dislodge your TV while you level it. Use extreme caution until you tighten the leveling and locking screws. Séura recommends checking knobs, screws, and bolts every two to six months. Temperature fluctuations, wind, and normal wear and tear can loosen hardware over time. - Page 13 Top Leveling Screw Allows for leveling adjustments of the TV after mounting.
- Page 14 Séura Outdoor TV Mounting Measurement Guide If mounting a Séura Outdoor TV model listed in the table below, use the corresponding measurements to locate the mounting plate template in the desired location on the wall as described in Step 1. In addition, use the bracket hole listed to determine which holes on the Slim Mount TV Brackets to line up with the VESA holes on the TV as described in Step 2.
- Page 15 Example Wall Location Shown for SHD2-55 with Soundbar 6 3/16 in 11 1/8 in 11 1/8 in 14 13/16 in SHD2-55 with Soundbar Outline...
-
Page 16: Specifications
Specifications SLIM WALL MOUNT Model: SW-2 DISPLAY COMPATIBILITY 42″ - 86″ Séura Outdoor TVs VESA COMPARABILITY Compatible with VESA mount patterns up to 600×400 MOUNTING PLATE DIMENSIONS 26.25″ w x 11.4″ h FINISH COLOR Black Powder Coat DURABILITY Acrylic E-Coated Steel... - Page 17 " 16 " 25mm 1" 6" 16 " 7" 5" 16 "...
-
Page 18: Limited Product Warranty
LIMITED PRODUCT WARRANTY For information regarding Séura’s warranty policy, please visit our website: www.seura.com/warranty. If the current Séura warranty policy is after your product purchase date, please contact Séura Customer Support to request warranty documentation from the date of your purchase.
Need help?
Do you have a question about the SW-2 and is the answer not in the manual?
Questions and answers