Subscribe to Our Youtube Channel
Related Manuals for Seura SW-2
Summary of Contents for Seura SW-2
- Page 1 WARRANTY REGISTRATION REGISTER FOR EXTRA BENEFITS Activate within 30 days of purchase: seura.com/activate " OUTDOOR TV SLIM WALL MOUNT 25mm 1" INSTALLATION GUIDE Model Number: SW-2...
- Page 2 Compatible with Séura Outdoor TVs: Shade Series: SHD1-55, SHD1-65, SHD1-75, SHD2-43, SHD2-55, SHD2-65, SHD2-75 Ultra Bright: STM3-55-U, STM3-65-U, STM3-86-U Safety Prior to the installation of this product, read all • When mounting in metal stud walls or cinder instructions. Keep this manual for future reference. block walls, an alternative anchor (not included) should used.
-
Page 3: Parts Included
½˝ Socket M10 Socket* tools for concrete installations. * Optional tools for concrete installations. List Model Number: Parts List SW-2 16 " 16 " Manual Slim Mount TV Brackets, qty. 2 Wall Mounting Template (located on inside bottom of box) -
Page 4: Installation Tools
Installation Tools The following tools may be required depending upon your particular Parts and Tools Required (not included) The following tools may be required depending on your particular installation. They are not included. ¼˝ Drill Bit for ˝ Electronic Stud Finder Wood Stud Pencil Level... - Page 5 Features Top Leveling Screws Allows for leveling adjustments of the TV after mounting Mounting Slots Allows for a variety of stud Directional configurations Mounting and lateral shift Arrows adjustments when mounting Lets you know your TV which edge is up Cable/Electrical Cut Out Large center cut out is convenient for power and...
-
Page 6: Installation
IMPORTANT: HANDLE THE TV IN A VERTICAL POSITION TO AVOID DAMAGE TO THE SCREEN. IF PLACING THE TV SCREEN-SIDE DOWN OR LEANING AGAINST A WALL DURING INSTALLATION, COVER THE SCREEN WITH A PROTECTIVE CLOTH OR BLANKET. Installation IMPORTANT: THIS PRODUCT MUST BE MOUNTED TO CONCRETE, STONE, BRICK OR WOOD STUDS. The wall must be able to support five times the weight of the television and the mount combined. - Page 7 3. Drill pilot holes Pre-drill the four marked holes on the wall 3-inches deep with a 7/32” drill bit. 4. Attach mounting plate Make sure the arrows on the mounting plate point up. Align the mounting plate with the pre-drilled holes.
- Page 8 Concrete, stone or brick wall mounting: See page 6 for mounting to a wood stud wall 1. Choose mounting location If mounting a Séura Outdoor TV, reference page 14 for measurements from the edges of the TV to the edges of the mounting template to properly place the template in the desired location on the wall. Note that it is NOT vertically centered on the TV screen.
- Page 9 3. Drill pilot holes Pre-drill the four marked holes on the wall 3-inches deep with a 7/16” masonry drill bit. Insert a plastic anchor into each of these holes. If necessary, lightly tap each anchor into place with a hammer. 4.
- Page 10 Step 2: Attach Slim Mount TV Brackets to TV Using a Philips #2 Screwdriver (or 6 mm Allen Wrench for 86” Ultra Bright TV), remove the four VESA mount screws from the back of the TV. Place the two identical Slim Mount TV Brackets flat against the back of the TV with the arrows pointed towards the top of the TV.
- Page 11 Step 3: Hang the TV IMPORTANT: NEVER TRY TO HANG A TV BY YOURSELF. ALWAYS USE AT LEAST TWO PEOPLE TO LIFT THE TV INTO PLACE. 1. Lift the TV and bring the back of the TV towards Do not let go of the TV until you are certain that the the wall, positioning it slightly above the mounting top and bottom hooks of both mounting brackets plate.
- Page 12 Step 4: Adjust the TV Caution: It is possible to dislodge your TV while you level it. Use extreme caution until you tighten the leveling and locking screws. Séura recommends checking knobs, screws, and bolts every two to six months. Temperature fluctuations, wind, and normal wear and tear can loosen hardware over time.
- Page 13 Top Leveling Screw Allows for leveling adjustments of the TV after mounting.
- Page 14 Séura Outdoor TV Mounting Measurement Guide If mounting a Séura Outdoor TV model listed in the table below, use the corresponding measurements to locate the mounting plate template in the desired location on the wall as described in Step 1. In addition, use the bracket hole listed to determine which holes on the Slim Mount TV Brackets to line up with the VESA holes on the TV as described in Step 2.
- Page 15 Example Wall Location Shown for SHD2-55 with Soundbar 6 3/16 in 11 1/8 in 11 1/8 in 14 13/16 in SHD2-55 with Soundbar Outline...
- Page 16 Séura website at F. Alterations, modifications, including use of unauthorized https://www.seura.com/warranty/. This warranty is valid only mount, or changes to a Product without Séura’s prior written with respect to Product sales in the U.S. and Canada.
- Page 17 be reasonably required by Séura to verify the Product’s warranty Toll-Free Technical Support: Please call 1-800-957-3872 to eligibility. Séura shall have no liability with respect to Products speak with a Séura Technical Support Representative. Séura whose serial number has been removed, defaced, replaced, or Representatives are available Monday-Friday, 8:00am-4:30pm otherwise tampered with in any manner.
-
Page 18: Specifications
Specifications SLIM WALL MOUNT Model: SW-2 DISPLAY COMPATIBILITY 42" - 86" Séura Outdoor TVs WALL PLATE DIMENSIONS 26.25" w x 11.4" h FINISH COLOR Black Powder Coat DURABILITY Acrylic E-Coated Steel MAXIMUM TV WEIGHT 200 lbs INSTALLATION SURFACE Solid / Brick / Stone / Masonry / Stud Wall... - Page 19 " 16 " 25mm 1" 6" 16 " 7" 5" 16 "...
- Page 20 For technical support, please contact Séura at 1-800-957-3872 during regular business hours: M-F 8:00 am - 4:30 pm, Central Time. 1230 Ontario Road Green Bay, Wisconsin 54311 1-800-957-3872 contacts@seura.com www.seura.com Publish date: August 10, 2020 Information is subject to change without notice.
Need help?
Do you have a question about the SW-2 and is the answer not in the manual?
Questions and answers