Table of Contents
Advertisement
MDS-SE9
Items of Error History Mode Items and Contents
Display
op rec tm
Displays the accumulated recording time.
When the accumulated recording time is more than 1 minute, displays the hour and minute
When less than 1 minute, displays "Under 1 min"
The display time indicates the time when the laser is set to high power more, which is about 1/4 of the actual
recording time.
op play tm
Displays the accumulated playback time.
When the accumulated playback time is more than 1 minute, displays the hour and minute
When less than 1 minute, displays "Under 1 min"
spdl rp tm
Displays the accumulated rotating time of the spindle motor.
When the accumulated rotating time is more than 1 minute, displays the hour and minute
When less than 1 minute, displays "Under 1 min"
retry err
Displays the accumulated number of retry errors during recording and playback.
Displays "r
during playback.
This is displayed in hexadecimal from 00 to FF.
total err
Displays the total number of errors.
Displays "total
err history
Displays the past ten errors.
Displays "0X ErrCd@@".
X is the history number. The younger the number, the more recent is the history (00 is the latest). @@ is the
error code.
Select the error history number by pressing the MD
retry adrs
Displays the past five retry addresses.
Displays "
Select the error history number by pressing the MD
er refresh
Mode for erasing the error and retry address histories.
Procedure
1. Press the [TAPE REC] button when displayed as "er refresh".
2. When the display changes to "er refresh?", press the [ENTER/START] button
When "Complete!!" is displayed, it means erasure has completed.
Be sure to check the following after executing this mode.
*Data has been erased.
*Perform recording and playback, and check that the mechanism is normal.
tm refresh
Mode for erasing the accumulated recording time and accumulated playing time.
Procedure
1. Press the [TAPE REC] button when displayed as "tm refresh".
2. When the display changes to "tm refresh?", press the [ENTER/START] button.
When "Complete!" is displayed, it means erasure has completed.
op change
Mode for erasing the accumulated time of op rec tm, op play tm.
Use these histories as a guide line for the time of replacement of the optical pick-up. If the optical pick-up
has been replaced, perform this procedure and erase the past history.
Procedure
1. Press the [TAPE REC] button when displayed as "op change".
2. When the display changes to "op change?", press the [ENTER/START] button.
When "Complete!" is displayed, it means erasure has completed.
spdl change
Mode for erasing the accumulated spdl rp tm time.
Use these histories as the guide line for the time of replacement of the spindle motor. If the spindle motor has
been replaced, perform this procedure and erase the past history.
Procedure
1. Press the [TAPE REC] button when displayed as "spdl change"
2. When the display changes to "spdl change?", press the [ENTER/START] button.
When "Complete!" is displayed, it means erasure has completed.
8
p
".
after "r" is the number of errors during recording.
". This is displayed in hexadecimal from 00 to FF.
ADRS
",
is the history number,
History
after "p" is the number of errors
or MD
Stick.
.
>
is the cluster with the retry error.
or MD
.
>
Stick.
Advertisement
Table of Contents
