Advertisement
Neckstrap Attachment
To attach the neckstrap, thread the ends of the neckstrap through the strap lug (Fig. 4) on each side of the binocular
(start at the bottom of the channel and push the strap up through the top), then back through the plastic buckle on
the strap. Adjust the position of the binoculars on your chest as they hang around your neck to your preference, by
changing the length of the strap section which passes through the strap channel and buckle by an equal amount
on each side. If you prefer to use an aftermarket strap that has metal O-rings, attach them to the "D-ring" at the
end of the short strap section rather than installing them directly on the lug, to avoid damaging the finish on the
binocular by contact with the rings.
Tripod Mounting
(50mm porro prism models only-see tech specs table)
Tripod Adapter
To attach the binocular to a tripod or monopod, unscrew (counter-clockwise) the "B" logo cap
(Bushnell
which covers the threaded socket at the far end of the center hinge (Fig. 5), and set it aside in
#161002CM)
a safe place. Use a compatible binocular tripod adapter accessory, such as the Bushnell model
#161001CM, to attach your Spectator Sport binocular to any standard tripod in a horizontal
position to provide a stable image during prolonged viewing.
Water Resistant
Your Bushnell Spectator Sport binocular has been designed for water resistance
to protect it from light rain or accidental splashes*. It is not fully waterproof or
"purged" and should not be submerged in water to avoid damage. *Note: BS1430
is not water resistant.
Changing the Color Tiles (Fig. 6)
To personalize your binocular, pry off the black tiles (use a fingernail, key or sm.
screwdriver) and replace them with red, white or blue tiles. Insert the wide end
Fig. 6 Color Tile
7
Advertisement
