Mitsubishi Electric PUMY-P250YBM2-ER Technical & Service Manual page 146

12-5. FUNCTION SETTING
12-5-1. PAR-4xMAA
("x" represents 0 or later)
1. Select ˝Service˝ from the Main menu, and press the [
Select ˝Setting˝ from the Service menu, and press the [
Select ˝Function setting˝, and press the [
2. The Function setting screen will appear.
Press the F1 or F2 button to move the cursor to one of the following: M-NET
address, function setting number, or setting value. Then, press the F3 or F4
button to change the settings to the desired settings.
Once the settings have been completed, press the [
A screen will appear indicating that the settings information is being sent.
To check the current settings of a given unit, enter the setting for its M-NET
address and function setting number, select Conf for the Function, and press
the [ ] button.
A screen will appear indicating that the settings are being searched for.
When the search is done, the current settings will appear.
When the settings information has been sent, a screen will appear
indicating its completion.
To make additional settings, press the [
screen shown in the above step. Set the function numbers for other
indoor units by following the same steps.
Note:
• Refer to the indoor unit Installation Manual for information about the factory settings
of indoor units, function setting numbers, and setting values.
• Be sure to write down the settings for all functions if any of the initial settings has
been changed after the completion of installation work.
TCH091
] button.
] button.
] button.
] button.
] button to return to the
146
Settings menu
Function setting
Lossnay
Service menu:
Cursor
F1 F2 F3 F4
Function setting
M-NET address
3
Function No.
32
Data 2
Function Set /Conf
Select:
Cursor Address
Function setting
M-NET address
3
Function No.
32
2
Data
Sending data
Function setting
M-NET address 3
Function No.
32
2
Data
Setting completed
Return: