Shark S3901 Series Owner's Manual page 14

fig. 3
WARNING: Always make sure the
Steam Mop is UNPLUGGED from the
wall when not in use and when filling,
changing the Mop Head or removing
or changing the Pocket Pad. Always
allow the Mop Head or the Pocket Pad
to cool before removing or changing.
To prolong the life of your Shark
Lift-Away Pro Steam Pocket
®
we recommend using distilled water.
Make sure you only add water to the
tank. Chemicals or cleaning solutions
(including vinegar) may damage the
Steam Mop and could be unsafe for
you and your family.
STEAM MOP ASSEMBLY
1 Screw the mop handle into the Steam Mop
housing (screwdriver not included). (fig. 1)
2 Secure the mop head inside the microfiber
Pocket Pad. (fig. 2)
3 Snap the Steam Mop Housing onto the Mop
Head. (fig. 3)
14 1.800.798.7398
fig. 1
fig. 4
4
®
Mop,
®
Open the water tank cap, fill the tank with
water, then replace and tighten the cap. (fig. 4)
Use the filling flask and pour water into the tank.
Do not overfill. Replace the cap on the water
tank. (fig. 5)
NOTE: To prolong the life of your Shark
Lift-Away Pro Steam Pocket
®
recommend using distilled water.
WARNING: When filling the Steam Mop
during use, make sure the mop head is
pointed towards the floor. Hot steam
can be released while filling the tank.
IMPORTANT: Do not use on unsealed wood
or unglazed ceramic floors. On surfaces that
have been treated with wax or some no wax
floors, the sheen may be removed by the heat
and steam action. It is always recommended to
test an isolated area of the surface to be cleaned
before proceeding. We recommend that you
check the use and care instructions from the
floor manufacturer.
fig. 2
fig. 5
®
Mop we
®