German pool SCC-WL60 User Manual page 6

Operation Instruction
Filling The Clean Water Tank
1. Clean Water Tank is located at the back end of the main unit. Please fill up prior to first use, or
whenever the tank is empty.
2. To take out the tank: Hold the tank firmly and pull out.
3. Open the tank lid and fill tank with water.
4. Reattach the water tank properly back onto the main unit.
Note:
• To avoid blocking the air duct, large pieces of garbage (eg. large pieces of paper, wrapping film,
etc.) in the area must be removed before using this product.
• This product is not a vacuum cleaner; it can only be used to suck up liquid, and thus must be
used together with the sprinkler. DO NOT dry vacuum.
• When this product is in operation, DO NOT touch the bristles on the roller brush, and DO NOT
block the air outlet grilles on the sides of the main unit.
• Press On/Off Button
starts to operate.
• Long-press Spray Button
the button, spraying will stop.
• Press Roller Brush Button
Light on the LED display will light up constant; press Roller Brush Button
brush will stop spinning and the corresponding indicator light will turn off.
• When product is in use, the Battery Power % will drop continuously. Please recharge when it drops
too low.
to turn on the product. LED display shows Battery Power %, and product
and the sprinkler will spray water continuously; when user lets go of
and the roller brush will start spinning, Roller Brush Indicator
P.6
again, roller