Advertisement
Echoflex Installation Guide
Temperature Sensor
Link to a Controller
The compatible target controller must be installed, powered, and within
range of the RTS.
Note:
controller and to unlink a linked device from a controller.
1. Press the tab on the bottom edge of the sensor body to remove the
back plate and access the [Teach] button.
2. Press the [Learn] button on the controller to activate Link mode. If
necessary, refer to the controller product documentation.
3. Press the [Teach] button on the sensor once to send a link message.
An LED blinks to confirm a successful transmission.
4. Deactivate Link mode on the controller before attempting to link to
any other controllers.
Battery Power
A battery is not required for normal operation if the sensor receives
adequate natural or artificial light. See the table in the
the next
page. A CR2032 battery (not provided) may be required to run
installation tests or when the artificial light is insufficient to power the
sensor.
To replace the battery:
1. Remove the sensor from the back plate by
pressing the key on the lower edge of the
sensor body.
2. Use a flatblade screwdriver to remove the
old battery from the holder.
3. Insert a new battery with the positive side
(+) facing up and press in place.
4. Replace the back plate and snap it in place.
Temperature Sensor
The linking process can be used both to link a device to a
Page 5 of 8
Light Level Test on
CR2032
battery
Teach
button
Sensor Back View
Echoflex
Advertisement
