Nostalgia Electrics NCCRT510PK Instructions Manual page 9

ASSEMBLY OF BASE SUPPORT
1. Attach Push Handle (E) from inside Main Unit (A) using supplied #1 Screws.
2. Insert Cross Bar (J) into the square inserts on the inside of Base Support
(I) and secure from below with two #1 Screws. Insert the Leg Assembly
(K) over the protruding ends of the Base Support (I) and fasten from the
inside of Base Support (I) using four #2 Bolts, and four #6 Nut Caps
3. Secure Main Unit (A) to Base Support (I) using four #2 Screws
4. Assemble Base Support (I) into the bottom of the Main Unit
(a) and the secure with four #2 bolts.
7