Advertisement
16
CaRE and CLEanInG
Remove spills and any heavy soiling as soon as
possible . Regular cleaning will reduce the difficulty
of major cleaning later .
CauTIOn
Before cleaning any part of the appliance, be sure
all controls are turned off and the appliance is
cool .
If ammonia or appliance cleaners are used, they
must be removed and the appliance must be
thoroughly rinsed before operating . Follow man-
ufacturer's instructions and provide adequate
ventilation .
ImPORTanT
Do not wash the control knobs in the dishwasher
or allow to soak - doing so may damage knob
parts .
Surface or area
Aluminum and vinyl
Painted and plastic control knobs
Painted body parts
Painted decorative trims
Control panel
Control knobs
figure 11: use cleaners with caution
Cleaning Recommendation
Using a soft cloth, clean with mild dish detergent and water . Rinse
with clean water, dry and polish with a soft, clean cloth .
Using a soft cloth, clean with mild dish detergent and water or a
50/50 solution of vinegar and water . Rinse with clean water, dry and
polish with a soft, clean cloth . Glass cleaners may be used, but do
not apply directly to surface; spray onto cloth and wipe .
Using a soft cloth, clean with mild dish detergent and water or a
50/50 solution of vinegar and water . Do not spray liquids directly on
the oven control and display area . Do not use large amounts of water
on the control panel - excess water on the control area may cause
damage to the appliance . Do not use other liquid cleaners, abrasive
cleaners, scouring pads, or paper towels - they will damage the fin-
ish .
Using a soft cloth, clean with mild dish detergent and water or a
50/50 solution of vinegar and water . (Do not wash knobs in dish-
washer or allow to soak - doing so may result in damage to knob
parts .) Knobs must be removed from the knob shaft for cleaning . To
remove control knob: turn to the OFF position, grasp firmly, and pull
off the shaft . To replace knob: line up the OFF marking and push the
knob into place . See page 19 for further information about reinstall-
ing the control knobs .
IMPORTANT: the knob installed for the SIMMER TO BOIL element
and DUAL element must be reinstalled to their same respective knob
shafts . Placing either of the knobs onto a different shaft may result in
damage to the knob or shaft .
Advertisement
