Mitsubishi Electric MLZ-KP25VF Installation Manual
Ceiling cassette type air conditioners
Hide thumbs
Also See for MLZ-KP25VF:
- Operating instructions manual (208 pages) ,
- Service manual (43 pages) ,
- Installation manual (12 pages)
Related Manuals for Mitsubishi Electric MLZ-KP25VF
Summary of Contents for Mitsubishi Electric MLZ-KP25VF
- Page 1 REFRIGERANT R32/R410A CEILING CASSETTE TYPE AIR CONDITIONERS MLZ-KP25VF MLZ-KP35VF MLZ-KP50VF English INSTALLATION MANUAL...
-
Page 2: Before Installation
FOR INSTALLER Required Tools for Installation CONTENTS 1. BEFORE INSTALLATION WARNING WARNING Do not install the unit by yourself (user). When plugging the power supply plug into the When installing the unit, securely connect the outlet, make sure that there is no dust, clogging, refrigerant pipes before starting the compressor. - Page 3 This manual only describes the installation of indoor unit. When installing the outdoor unit, refer to the installation manual of outdoor unit. CAUTION Install an earth leakage breaker depending on the Do not operate the air conditioner during interior installation place. the outdoor unit.
- Page 4 IMPORTANT NOTES WARNING piping. Service space ACCESSORIES * Note: EN-3...
-
Page 5: Indoor Unit Installation
2. INDOOR UNIT INSTALLATION 2-1. CEILING OPENINGS AND SUSPENSION BOLT INSTALLATION LOCATIONS EN-4... -
Page 6: Hole Drilling
Unit suspension procedures 2-2. HOLE DRILLING 2-3. DRAIN PIPING EN-5... - Page 7 EN-6...
-
Page 8: Flaring Work And Pipe Connection
Note: 3. FLARING WORK AND PIPE CONNECTION 3-1. PIPING WORK [When using pipe with super insulating material] EN-7... -
Page 9: Flaring Work
3-2. FLARING WORK 90° 3-3. PIPE CONNECTION WARNING Indoor unit connection When installing the unit, securely connect the refrigerant pipes before starting the compressor. WARNING not allowed indoors. When connecting the refrigerant piping by brazing, Outdoor unit connection prior to connecting indoor unit to outdoor unit. [When using pipe with super insulating material] When using pipe with super insulating material... -
Page 10: Grille (Option) Installation
Checking the remote (infrared) signal reception Water drainage check Emergency operation switch (E.O. SW) Caution: To the user 5. GRILLE (OPTION) INSTALLATION EN-9... -
Page 11: Pumping Down
6. PUMPING DOWN WARNING When pumping down the refrigerant, stop the compressor before disconnecting the refrigerant pipes. The compressor may burst if air etc. get into it. WARNING EN-10...