Table of Contents
Advertisement
SYSTEMS AND OPERATION
TANKLESS WATER HEATER 199
2.5 SEQUENCE OF OPERATION
When the unit is powered up the controller enters a self-diagnostic mode, and
displays the controller software version in the main display.
The sequence of operation is as follows:
1.
The unit receives a call for
sensor.
2.
The unit performs a safety check and energizes the fan for a pre-purge
(Service Display = 3).
3.
Once the 5-second pre-purge is complete, the unit enters a 5-second trial for
ignition (Service Display = 4). If the unit fails to ignite, the unit will complete
another 5-second pre-purge then 5-second trial for ignition. This is repeated
4 times before a hard lock-out occurs. The Return button
to reset the controller and begin another trial for ignition.
Once the burner is lit and flame has been proven the unit operates as it is
4.
programmed (Display = + for domestic hot water).
5.
If the unit exceeds its target temperature and there is still a call for hot water
the burner will turn off. (Service Display = 1)
6.
If the burner is on to maintain the heat exchanger temperature for DHW
Comfort mode (Service Display = 7).
If the burner is on for frost protection (Service Display = 9).
7.
MAIN
SERVICE
DISPLAY
DISPLAY
OFF
-
(blank)
(blank)
XXX
1
XXX
2
XXX
3
XXX
4
+
XXX
XXX
7
9
XXX
Table 8: Operating Display and Service Display Codes.
for domestic hot water heating from the internal flow
DESCRIPTION
The unit is OFF. Press the space above the dot for 2
seconds to turn on the unit
No Call for Hot Water - Standby
Unit water temperature exceeds target, call still present
Self-test – When power is applied to the unit the
controller enters a self diagnostic mode for 5 seconds
Fan Pre-purge and Post-purge
Trial for Ignition and Flame Proving
Heating – DHW
Burner on for DHW Comfort mode
Freeze Protection mode
must be pressed
.
2-5
Advertisement
Table of Contents
