Advertisement
4.1
Operation
4.1.1
Hold the unit by the housing and slide the ON/OFF switch up. This turns the camera, lighting, and
monitor on. To adjust the illumination at the tip, turn the control dial on the side of the unit.
4.1.2
Manipulate the shaft toward the area under investigation while viewing the monitor. The shaft can
be manoeuvred and manipulated into more complex paths.
4.2
Mirror
4.2.1
To attach mirrors, screw the mirror onto the end of the tip.
4.3
Video Out Port (Fig.3)
4.3.1
The bore scope provides an external video signal via an AV cable. This signal can be utilised by a
compatible monitor or recording device.
WARNING! The handheld monitor unit is not water resistant. The shaft and tip are water resistant.
Ensure Correct Orientation Of
Battery Pack.
Fig.2
5. MAINTENANCE
5.1
Battery Replacement
5.1.1
Slide off the battery cover at the base of the handle.
5.1.2
Tilt the battery pack from the bottom of the bore scope housing and remove it.
5.1.3
Remove the old batteries (dispose of batteries according to local authority guidelines) and replace
with 4 x new AA cells, ensure correct polarity - see markings on battery pack.
5.1.4
Relocate the battery pack in the bore scope housing; ensure the correct pack orientation (Fig.2).
5.1.5
Replace the battery cover by sliding back into place.
5.2
Cleaning and Storage
5.2.1
Wipe the bore scope tip, shaft and housing with a clean, soft cloth to remove residue and moisture.
5.2.2
Wash the bore scope tip and shaft with a cleaning liquid and rinse with water, then dry.
5.2.3
Gently clean the tip lens with a lens cleaner such as isopropyl alcohol and a cotton bud.
DO NOT submerge the bore scope in water - the bore scope monitor is not water resistant.
NOTE: The bore scope MUST be completely dry prior to returning it to the storage case.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
Follow battery removal guide 5.1 above and dispose of batteries according to local authority guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak's
registered compliance scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705
Parts support is available for this product. To obtain parts please email sales@sealey.co.uk or phone 01284 757500.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including
postcode.
Environmental Protection.
Battery Removal
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
AV-out port
Tip Brightness Control Dial
01284 757500
Web
01284 703534
email
VS8193
Fig.3
www.sealey.co.uk
sales@sealey.co.uk
Issue: 1 - 05/01/10
Advertisement
