Advertisement
4. TEST PREPARATION
4.1.
Be sure area around battery is well ventilated while battery is being tested.
4.2.
Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.
4.3.
Inspect the battery for cracked or broken case or cover. If battery is damaged, DO NOT use tester.
4.4.
If the battery is not sealed maintenance free, add distilled water in each cell until battery acid reaches level specified by the
manufacturer. This helps purge excessive gas from cells. DO NOT overfill.
4.5.
If necessary to remove battery from vehicle to test, always remove earth terminal from battery first. Make sure all accessories in the
vehicle are off to ensure you do not cause any arcing.
5. OPERATION
NOTE: Each time you connect the tester to a battery, the tester will run a quick cable verification to ensure a proper connection
through the output cables to sensors in the clamp jaws. If the connection checks out OK, the tester will proceed to the Home Screen.
If the connection is poor, the display will show "CHECK CABLE". In this case, check cable connections for visible signs of damage, as
you may need to re-connect the clamps to the battery or replace the cable end.
5.1.
BEFORE TESTING:
5.1.1.
Before you test a battery in a vehicle, turn off the ignition, all accessories and loads. Close all the vehicle doors and the boot/tailgate.
5.1.2.
Make sure the battery terminals are clean. Wire brush them if necessary.
5.1.3.
Clamp the black load lead to the vehicle negative battery terminal. Clamp the red load lead to the vehicle positive battery terminal.
Please clamp on the lead part of the terminal only. Clamping on the iron part of the terminal will lead to wrong test results.
5.2.
MAIN MENU
SYSTEM
ANALYSER
BATTERY TEST
XX.XX V
SYSTEM TEST
XX.XX V
IN-VEHICLE TEST
XX.XX V
LANGUAGE
SELECT
BRIGHTNESS
© Jack Sealey Limited
View the following screens by pressing ◄/► to switch between all functions and settings.
Press ENTER to perform battery test.
Press ENTER to perform an alternator
test.
Press ENTER to perform a full in-vehicle test.
Press ENTER to change language.
Press ENTER to start adjusting screen brightness.
Original Language Version
BT2011 | Issue:1 02/03/20
Advertisement
