XTline XT102730 User Manual page 21

ELECTRIC TOOL HANDLING AND MAINTANCE
a)
b)
c)
accessory replacement or storage of tool. These preventive safety precautions reduce a risk
of accidental starting of tool.
d) When not in use, idle tools should be stored in a place out of reach of visitors and children.
e) Maintain careful manipulation with the tool. Check for deflecting or jamming of turning parts, damaged
parts or other conditions which may influence operating with the tool.
f) Keep tools sharp and clean for better and safer performance. Properly serviced tools are less likely to
become covered in impurities and are better controlled.
g) Use equipment recommended by the producer of your model only. Modifications and accessories used at
one tool may be dangerous when used with another model.
Warranty does not apply for accessories!
USING
Main operating switch and speed control - Fig. 4
This tool is equipped with a main operating switch, which is used both to turn the device on and
off, and to control the cutting speed.
- To start the appliance, first press the locking button of the main switch (6) and then the main operating switch (4).
- Release the main operating switch (4) to stop the operation of the device.
- To change the cutting speed, simply press the main operating switch more or less. The more you press the switch,
the more the cutting speed will increase.
Do not force the tool.
Do not use if the ON/OFF switch does not work properly.
Disconnect the plug from socket and/or battery from the tool prior any adjustment,