Jeep GRAND CHEROKEE 2023 Information Manual page 33

32 STARTING AND OPERATING
NOTE:
EPB will not operate if the 12 Volt battery is depleted.
A P B
UTO ARK RAKE
Any single Auto Park Brake application can be bypassed by
pushing the EPB switch to the release position while the
transmission is placed in PARK.
S H
AFE OLD
SafeHold is a safety feature of the EPB system that will
place the transmission in PARK, and engage the parking
brake automatically if the vehicle is left unsecured while
the ignition is in ON/RUN.
The parking brake will automatically engage if all of the
following conditions are met:
 The vehicle is at a standstill.
 There is no attempt to press the brake pedal or accel-
erator pedal.
 The seat belt is unbuckled.
 The driver door is open.
SafeHold can be temporarily bypassed by pushing the EPB
switch while the driver door is open. Once manually
bypassed, SafeHold will be enabled again once the vehicle
reaches 12 mph (20 km/h) or the ignition is turned to the
OFF position and back to ON again.
H 'N G — I E
OLD O F QUIPPED
Hold 'N Go is a comfort feature that allows the driver to
remove their foot from the brake pedal once the vehicle
has come to a stop. The vehicle must be held at a
standstill for a predetermined amount of time by hydraulic
braking. The EPB will then engage and continue to hold
the vehicle at a stop until the driver applies the accelerator
pedal. Hold 'N Go can be activated or deactivated by
pushing the HOLD button located on the switch bank.
HOLD Switch
The following conditions must be met for Hold 'N Go to
activate:
 Driver's door closed
 Driver's seat belt fastened
 Vehicle is at a standstill
 Forward gear is selected
 ACC is not engaged
 EPB is not applied
 ParkSense Active Park Assist system auto parking
maneuver is not activated