Selve i-R Light Sensor Operating Instruction page 24

Explanation of functions/terms used
EN
TEST MODE
This mode is used to test the i-R Light Sensor. In TEST MODE the
times for the sunshade function are reduced from minutes to
seconds.
Press the manual/automatic button until the control light flashes
green 3 times. The TEST MODE will remain active for 5 mins.
Manual/automatic button
The manual/automatic button can be used to deactivate auto-
matic control commands (e.g. sun protection function, twilight
function).
In manual mode the control light flashes with a red light when
pushing the manual / automatic button.
In automatic mode the control light flashes with a green light when
pushing the manual / automatic button.
Control light
If a control command is executed, the control light will light up
briefly to signalise this.
Green: UP
Red: STOP
Yellow: DOWN
If the battery starts running out, the control light flashes during
transmission.
The transmitter power and/or radio range is reduced when the
battery is running low. If the control light is no longer lit when the
button is pressed, the batteries must be changed.
24