Honeywell NOTIFIER FW-MM Installation And Maintenance Instructions page 2

Wireless monitor module

Hide thumbs

page of 2

/ 2
Bookmarks

FIGURE 3. BATTERY COMPARTMENT

BATTERY

COMPARTMENT

MOUNTING

The FW-MM(A) mounts directly to an SMB500(-WH) electrical box. (See

Figure 4.) To avoid interference with the wireless network metal elec-

trical boxes are NOT recommended. Non-metal surface mounted elec-

trical boxes (SMB500/SMB500-WH) are available from Notifier. If not

using an SMB500(-WH), the minimum mounting opening dimensions for the

FW-MM(A) are 4 in. X 3¾ in. x 1½ in. deep.

NOTE: Do not attach the module to temporary structures such that the place-

ment could be altered.

WIRING

NOTE: All wiring must conform to applicable local codes, ordinances, and reg-

ulations. This module is intended for power limited wiring only. FW-MM(A)

must be within 3 feet of monitored device when using field wiring or 20 feet

in non-metallic conduit. In Canada, wiring methods shall be in accordance

with CSA C22.1 Safety Standard for Electrical Installations, Canadian Electri-

cal Code, Part 1, Section 32.

Install module wiring in accor-

dance with the job drawings

and appropriate wiring dia-

grams.

Set the address on the module

per job drawings.

Secure module to electrical

box (supplied by installer), as

shown in Figure 3.

Use of these products in combination with non-Honeywell products in a wireless mesh

network, or to access, monitor or control devices in a wireless mesh nework via the inter-

net or another external wide area network, may require a separate license from Sipco, LLC.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Do not make changes to the equipment. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de

brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

This device utilizes the Honeywell915 rev A radio module and complies with IFETEL standard(s). IFT: RCPHOSW14-1983

Notifier

and SWIFT ® are registered trademarks of Honeywell International, Inc.

BATTERY

COMPARTMENT

DOOR

FIGURE 5. TYPICAL MONITORING CONFIGURATION

ONLY ONE UL/ULC LISTED CONTACT

CLOSURE MAY BE USED

3.9K EOL

RESISTOR

A2143-10