Door Reversal; Cold Weather Storage - Maytag Neptune MAH6500AWW Installation Instructions Manual

DOOR REVERSAL

Clothes washer door swing direction can be changed by following this procedure.
1. Swing door fully open and support it. Remove the
center screw from the hinges and the hinge covers. A
total of four screws are removed.
2. Lift the door upward and then pull outward. The door
and its hinges should disengage from the cabinet. If
the hinges seem to bind, press the plastic area near
the hinge toward the hinge.
3. Remove the hinge covers by pulling upward and then
outward, just like the hinges.
4. Remove the screws that mount the hinges to the door.
A total of four screws are removed.
5. Transfer the four color matched
screws that attach the inner and
outer door together to the other
side of the door.
6. Attach the hinges to the door. Be
sure that hinge is oriented so it will
fit into the slots on the cabinet.
7. Remount the door onto the cabinet. Secure
using the original mounting screw.
8. Mount the hinge covers to the opposite side
of the door opening with their center screws.
The hinge covers are not symmetrical.
There is a chamfer to accommodate the
mounting screw.

COLD WEATHER STORAGE

The following precautions should be taken if a washer is to be stored, after use, where it would be subject to
freezing conditions.
1. Turn off the water supply, then remove the inlet hoses.
2. Select a fill cycle and energize the water valve by selecting a warm water setting. A few seconds of fill is
sufficient.
3. Disconnect from electrical supply.
4. Remove the drain hose cover from lower middle of cabinet back.
5. Lower the drain hose to floor level and tilt washer backwards to remove water from the drain hose and
pump.
6. Re-install the drain hose cover.
Page 5