System Clock Settings - NEC IE-789801-NS-EM1 User Manual

3.2.2 System clock settings

Frequency of System Clock
When using clock that is
already mounted on
emulation board
When using clock mounted
by user
When pulse is input from
target system
Caution When a pulse is input from target system, open the configuration dialog box when starting the
integrated debugger (ID78K0S-NS) and select "External" in the area (Clock) for selecting the CPU's
clock source (this selects the user's clock).
Remark The IE-789801-NS-EM1's factory settings are those listed above under "when using clock that is already
mounted on emulation board".
(1) When using clock that is already mounted on emulation board
When the IE-789801-NS-EM1 is shipped, a 6 MHz crystal oscillator is already mounted in the IE-789801-NS-
EM1's X1 socket. If the IE-789801-NS-EM1 is in the same state as when shipped, no hardware settings are
required.
When starting the integrated debugger (ID78K0S-NS), open the configuration dialog box and select "Internal" in
the area (Clock) for selecting the CPU's clock source (this selects the emulator's internal clock).
CHAPTER 3
Table 3-1. System Clock Settings
6 MHz
Other than 6 MHz
User's Manual U13390EJ2V0UM
INSTALLATION
IE-789801-NS-EM1
Parts Board (X1)
Oscillator used
Oscillator assembled by user
Oscillator not used
CPU Clock Source
Selection (ID)
Internal
External
23