Table of Contents
Advertisement
This product complies with all relevant European
directives, for details please see the separate product
specific Declaration of Conformity (DOC) sheet.
Introduction
This flail-blade lawn cutting deck is mounted to a
walk-behind traction unit and is intended to cut grass
and other low-lying vegetation within the limitations
stated in this manual. Use in any other way is considered
as contrary to the intended use. You are responsible for
operating the product properly and safely.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a dealer,
or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. The model
and serial numbers are stamped on a plate on the right
side of the cutting unit. Write the numbers in the space
provided.
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 1),
which signals a hazard that may cause serious injury
or death if you do not follow the recommended
precautions.
1. Safety alert symbol
This manual uses 2 other words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
© 2012-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Contents
Introduction................................................................. 2
Safety ........................................................................... 3
Sound Power Level............................................... 3
Sound Pressure Level ........................................... 3
Vibration Level .................................................... 3
Safety and Instructional Decals ............................. 3
Product Overview ........................................................ 4
Specifications ....................................................... 4
Attachments/Accessories..................................... 4
Operation..................................................................... 4
Setting the Height of Cut ...................................... 4
Adjusting the Anti-scalp Skids .............................. 5
Maintenance................................................................. 6
Recommended Maintenance Schedule(s) .................. 6
Preparing the Machine for Maintenance ................ 6
Greasing the Machine........................................... 6
Maintaining the Blades ......................................... 7
Cleaning Under the Guards .................................. 7
Checking the Rubber Discharge Guards................ 8
Checking and Adjusting the Brake......................... 8
Replacing the Gearbox Drive Belt ......................... 8
Replacing the Rotor Drive Belt.............................. 9
Checking the Gearbox Oil Level ........................... 9
Storage....................................................................... 10
2
Contact us at www.Toro.com.
Printed in the UK.
All Rights Reserved
Advertisement
Table of Contents
