Before Using; Using The Kettle; U.k. Wiring Instructions - Princess Roma 232183 Instructions For Use Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
PRINCESS WATER KETTLE ROMA 0.5L

BEFORE USING

Read these instructions thoroughly first and keep them for future reference. Check whether the voltage in
the home corresponds with that of the appliance. Only connect this appliance to an earthed socket.
The kettle comes complete with boil-dry protection, a reset button and an indicator light.

USING THE KETTLE

The kettle should be used exclusively for boiling water; never use it with other liquids or ingredients.
First boil a full kettle of water to clean the kettle and discard this water.
Place the kettle on a sturdy, stable surface. Always fill the kettle less than maximum indicator. Plug in and
turn the kettle on by pressing the reset button in the handle. The indicator lamp will be illuminated. When
the water boils, the kettle switches itself off automatically and the indicator light goes out. Allow the
appliance to cool down. Don't operate the kettle when it is empty. If the kettle is accidentally switched on
when empty, the boil-dry protection will automatically switch it off.
Adding water will then cool the boil-dry protection mechanism enabling you to use the kettle as normal.
NOTE:
Do not fill the kettle higher than the MAX level indicator or boiling water may spray out.
CLEANING
FIRST REMOVE THE PLUG FROM THE SOCKET AND ALLOW THE KETTLE TO COOL DOWN
BEFORE CLEANING.
The outside of the kettle can be wiped down with a damp cloth.
DESCALING
Use a descaling agent suitable for household appliances, such as coffee machines. Do not switch the kettle
on during descaling, but allow the agent to soak in while the kettle is still cool. Rinse the kettle several
times with clean water.
PRINCESS TIPS
- Set the kettle on a sturdy, stable surface. Do not operate the kettle on an inclined plane.
- Do not operate the kettle unless the element is fully immersed.
- If the kettle is overfilled, boiling water may be ejected.
- Never immerse the kettle in water or any other liquid.
- The exterior can become quite hot. Only pick up the kettle using the handle.
- Ensure that the appliance is not so close to the edge of a table, counter top, etc., that someone could
knock it over. Do not allow the cord to hang over the edge or on the floor, as someone may become
entangled or trip over it. Remember: the kettle contains hot water!
- Do not use the equipment if it is damaged, or if the lead is damaged. Send it to our Service
Department. With this type of appliance, a damaged cord should must only be replaced by our service
department using special tools.
- Do not place the appliance on or directly adjacent to a warm hotplate or other source of heat.
- Always unplug the appliance before cleaning or if any fault develops.
- Children should be supervised to ensure that they do not play with the appliance.
- The use of this appliance by children or persons with a physical, sensory, mental or motorial disability,
or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety
should give explicit instructions or supervise the use of the appliance.
- The appliance is not intended for use by young children or infirm persons without supervision

U.K. WIRING INSTRUCTIONS

The wires in the mains lead are coloured in accordance with the following code:
BLUE = neutral, BROWN = LIVE, GREEN-YELLOW = EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the
colour markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with
the letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked
with the letter L or coloured red.
ART. 232183
4

Advertisement

Table of Contents
loading

Table of Contents