Display Screen Overview - Furuno WV-100 Operator's Manual

1.2

Display Screen Overview

The screen looks something like the one shown below when the radar is transmitting pulses and
waves are being analyzed.
3 3
6 6
No. Name
1 Wave spectrum display area
2 Radar echo display area
3 Wind sensor information
4 Own ship information
5 Radar information
6 Significant wave height
7 First wave information
8 Second wave information
9 Software display state
10 [MENU]
11 Orientation mode box
12 Update time box
13 Camera icon/System informa-
tion box
14 Alert information box
While wave analysis is stopped, the PC screen looks like the following depending on the radar
state.
• Radar is in stand-by: "RADAR ST-BY" is displayed at the center of the left and right screens.
• Radar is disconnected: "NO RADAR" is displayed at the center of the left and right screens.
When the wave analysis contains an error, the message "Wave analysis is not available." appears
at the center of the left screen.
1 1
4 4
7 7
Shows 2D wave spectrum.
Shows radar echo for wave analysis from the specified ra-
dar.
Shows wind direction and wind speed.
Shows HDG (heading), COG (Course Over Ground), and
SOG (Speed Over Ground).
Shows antenna ID, band width, transceiver type, pulse
width, display range of the connected radar.
Shows significant wave height.
Shows wave height, wave direction and wave period for first
wave.
Shows wave height, wave direction and wave period for
second wave.
Selects the software display state. (Minimize, Maximize
(grayed out, no use), Close from the left)
Opens/closes the menu.
Selects the orientation mode.
Shows the time of the most recent wave analysis.
• Camera icon: Takes a screenshot.
• System information: Shows sea-trial mode*, manual ad-
justment mode of wave height, and software version.
*: No indication for normal mode.
Shows active alerts (alert icon and alert message).
3
1. OPERATIONAL OVERVIEW
2 2
5 5
13 25
8 8
Description
9 9
10 10
11 11
12 12
13 13
14 14