Connecting Tv Or Catv; Connecting A Vcr - Maxent MX-42V1 Owner's Manual

Display Connections

Connecting TV or CATV

Connecting to TV or Cable TV
Make sure your monitor is equipped with a TV tuner. You can tell by looking at the connection jacks located
on the back of the monitor. If there is a threaded-screw type of connector (called the RF connector), then you
have a TV tuner. If you do not see this type of connector, then you do not have a TV tuner installed.
Connect the RF cable from the antenna or
cable socket to the RF connector labeled as
TV1 or TV2 on the back of the monitor.
Notes:
If your monitor is not equipped with a TV
tuner, please contact your local sales
representative for purchase.
If there is only one antenna connector and
your monitor is equipped with two TV
tuners, you will need to use a antenna
signal splitter to connect to the two RF
connectors.

Connecting a VCR

Using S-Video Input
Connect the S-Video (4-pin DIN) connector from
the VCR to the S-Video input on the back of
monitor.
Connect the red (R) and white (L) audio jacks
from the VCR to the (R) and (L) audio-in jacks
located next to the S-Video connector.
Note:
There are two sets of S-Video inputs
provided.
Using Composite Input
Connect the yellow (video) out connector from
the VCR to the yellow video input on the back of
monitor.
Note:
There are two sets of composite inputs
provided.
14