Rigging Details - Daikin DSG Series Installation Instructions Manual

REMOVE
COVERS
17"
12" SUPPLY
6 3/16"
Horizontal Discharge Duct Connections

RIGGING DETAILS

T
O PREVENT PROPERTY DAMAGE, THE UNIT SHOULD REMAIN IN AN UPRIGHT
POSITION DURING ALL RIGGING AND MOVING OPERATIONS.
LIFTING AND MOVING WHEN A CRANE IS USED, PLACE THE UNIT IN AN
ADEQUATE CABLE SLING.
I
F UNITS ARE LIFTED TWO AT A TIME
CONDENSER END OF THE UNIT MUST NOT BE USED
42"
LENGTH IS TO PREVENT DAMAGE TO THE UNIT
.
IS RECOMMENDED
Provisions for forks have been included in the unit base
frame. No other fork locations are approved.
T
O PREVENT POSSIBLE EQUIPMENT DAMAGE, PROPERTY DAMAGE, PERSONAL
INJURY OR DEATH, THE FOLLOWING BULLET POINTS MUST BE OBSERVED
WHEN INSTALLING THE UNIT.
• Unit must be lifted by the four lifting holes located at the
base frame corners.
• Lifting cables should be attached to the unit with shackles.
• The distance between the crane hook and the top of the unit
must not be less than 60".
• Two spreader bars must span over the unit to prevent dam-
age to the cabinet by the lift cables. Spreader bars must
be of sufficient length so that cables do not come in contact
with the unit during transport. Remove wood struts mount-
ed beneath unit base frame before setting unit on roof curb.
These struts are intended to protect unit base frame from
fork lift damage. Removal is accomplished by extracting
the sheet metal retainers and pulling the struts through the
base of the unit. Refer to rigging label on the unit.
11" 4 7/8""
7 3/8"
WARNING
T
O FACILITATE
CAUTION
,
THE FORK HOLES ON THE
. M
INIMUM FORK
;
HOWEVER
WARNING
Important: If using bottom discharge with roof curb, ductwork
should be attached to the curb prior to installing the unit.
Ductwork dimensions are shown in Roof Curb Installation
Instructions.
Refer to the Roof Curb Installation Instructions for proper
curb installation. Curbing must be installed in compliance
with the National Roofing Contractors Association Manual.
Lower unit carefully onto roof mounting curb. While rigging
25"
unit, center of gravity will cause condenser end to be lower
than supply air end.
To assist in determining rigging requirements, unit weights
are shown as follows:
A
, 48"
Y
COMPRESSOR
B
Corner & Center of Gravity Locations
A* X
Model (in)
DSG036045* 37
DSG036070* 37
DSG036090* 37
DSG048070* 37
DSG048090* 37
DSG048115* 37
DSG060090* 34
DSG060115* 34
DSG060140* 34
* Note: Weights are calculated without accessories installed.
8
CONDENSER
COIL
EVAPORATOR COIL
CG
X
Y Shipping Operating
(in) Weight Weight
30 590 565
30 595 570
30 600 575
30 630 605
30 635 610
30 640 615
28 640 615
28 644 619
28 645 620
C
RETURN
SUPPLY
D
Corner Weights (lbs)
A B C D
107 176 107 176
108 178 107 177
109 179 108 179
114 188 114 189
115 190 115 190
116 192 116 191
116 192 116 191
117 193 117 192
117 193 117 193