Table of Contents
Advertisement
Seeing the IS operating statuses in the
viewfinder
When using a camera provided with a function for receiving
the signals indicating that the IS function is operating or
stopped from the lens side and displaying this operating
status on its viewfinder, it is possible to connect only the IS
Operation Switch and operate it to perform these functions.
Remove the IS indicator unit that is connected partway
along the cable from the IS operation unit.
Mounting the Macro Controller
(Option)
When using the lens with the macro function, using the
optional macro controller enables macro operation. For
details, refer to the macro controller operation manual.
1
Loosen the large and small lock knobs of the clamper,
then mount the clamper to the left pan handle of the
tripod.
2
After mounting the clamper to the pan handle of the
tripod, tighten the large and small lock knobs of the
clamper to secure the clamper.
3
Mate the rose joint of the macro controller with the
rose joint of the clamper.
4
Tighten the mounting knob of the clamper to firmly
secure the zoom demand.
Lens
"AUX (IS Controller)"
Connector
IS Operation Switch
Fixing Belts
IS Indicator Unit
(or Viewfinder)
Large Lock Knob
Small Lock Knob
Mounting Knob
5
Connect the cable connector (female) of the macro
controller to the connector of the macro controller.
Then connect another side of the connector (male) of
the cable to the "SW. BOX" connector on the rear side
of the lens.
Lens
E5
1 HOW TO MOUNT
Macro Controller
Clamper
"SW. BOX" Connector
Cable of Macro
Controller
Macro Controller
Pan
Handle
Advertisement
Table of Contents
