Technical Specifications - Zephir ZHC40N Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

VII. Make Frying Chips by yourself

For the purpose to have the best effect, we advise you to use the pre baked chips (e.g. frozen chips). To

make frying chips by yourself, please follow the steps below.

1. Husk the potatoes and cut them into small chips.

2. Soak the potato chips in a bowl for at least 20 minutes, fetch them out and drain them on the paper

for cooking room use.

3. Pour olive oil into the bowl with a spoon, put the potato chips into the bowl and mix them round,

until all the potato chips are oiled evenly.

4. Fetch the potatoes chips out of the bowl with your hands or kitchen wares, leave the redundant oil in

the bowl. Then pour the potato chips into the frying tank.

Notice:

1) Put the frying tray in the frying tank before put the potato chips into the frying tank.

2) Do not pour all the potato chips into the frying tank in just one time, thus to prevent too much oil

being collected at the bottom of the frying tank in the end.

5. Fry the potato chips following the instructions in this chapter.

CLEANING

Clean the product each time after using.

The inside of the frying tank, frying tray and the product are all covered with non-sticking painted coat.

Do not use metal kitchen wares or abrasive cleaning material to do the cleaning, for this will damage

the non-sticking painted coat.

1. Pull out the plug from the power socket, let the product cool down.

2. Use wet cloth to scrub the outside part of the product.

3. Clean the frying tank or frying tray with hot water, detergent and non-abrasive sponge , please add

hot water into the frying tank together with some detergent. Put the frying tray into the frying tank, and

then soak the frying tank and the frying tray for 10 minutes.

4. Clean the inside of the product with hot water and non-abrasive sponge.

5. Use cleaning brush to clean the heating components, swept away remaining food residual.

6. A timely manner with a clean brush to clean the air inlet opening and the air outlet opening, so as not to affect the air

inlet and the outlet air flow.

STORAGE

1. Pull out the plug of the product, and let it cool down thoroughly.

2. Make sure that all the components are cleaned and dried.

3. Pack up the power wire.