Page 1
GT410 ATF System Service Centre GT410 ATF System Service Centre...
Page 2
Never allow improperly trained personnel to perform these procedures or operate equipment. Read and understand the User’s Manual before attempting to operate the GT410. Prohibit running the EXCHANGE or ADD function before connecting to the vehicle.
GT410 ATF System Service Centre CONTENTS FEATURES..................................3 WORKING CONDITIONS..............................3 SPECIFICATIONS................................3 STRUCTURE...................................4 1. O UTLINE 2. C ONTROL PANEL OPERATIONS................................. 6 1. P REPARATION 1.1Jack vehicle................................6 1.2 Connecting hose.................................6 .3 Power cables connection...............................7 1.4 Check-up................................... 7 2. F ILLING LIQUID 2.1 Filling detergent................................
ATF as required, the excessive or shortage filling will cause the damage to auto transmission. GT410 auto transmission changer can complete the flush and fluid exchange in 15 minutes for transmission, torque converter and radiator. The fluid exchange rate is nearly 100%.
GT410 ATF System Service Centre 2. Control panel The control panel is shown as in Fig.2. Fig.2 Description: DESCRIPTION ICON NAME LEFT arrow、RIGHT arrow Set parameter、Item select DOWN arrow、UP arrow Item select Parameter confirm, Function ENTER Confirm key execute EXIT Return key、Exit key...
Locate a matched connector inside box and connect it to the disconnected adapter. 2) Connect the two hoses marked “TO TRANSMISSION” of GT410 to the disconnected two ends of the hoses of automatic transmission (no consideration of the fluid flow). Refer to Fig.4.
Connect the power cables clamps of the unit to the two poles of the vehicle battery. 1.4 Check-up 1) Start the engine, and ensure that there is no leakage in pipeline. 2) Open the GT410 power switch and ensure that the power of the unit is normal. 2. Filling liquid 2.1 Filling detergent When you are ready to perform the circulating cleaning for auto transmission, fill proper detergent from the fill port under the circumstance that there is no new fluid.
GT410 ATF System Service Centre 4.2 Decrease fluid amount If the quantity of the ATF is more than the standard amount, it is necessary to decrease the fluid amount inside transmission. Select adjust function, set the amount of return used fluid, press the ENTER key to run.
Maintenance Pay attention to each connection to check if there is any leakage during fluid exchange. When any leak is found, stop the GT410 immediately and check for the unit. Start to exchange fluid again after reconnection is made.