Page 1
GT510 ATF System Service Centre GT510 ATF System Service Centre...
Page 2
Never allow improperly trained personnel to perform these procedures or operate equipment. Read and understand the User’s Manual before attempting to operate the GT510. Prohibit running the EXCHANGE or ADD function before connecting to the vehicle.
GT510 ATF System Service Centre CONTENTS FEATURES..................................3 WORKING CONDITIONS..............................3 SPECIFICATIONS................................3 STRUCTURE...................................4 1. O UTLINE 2. C ONTROL PANEL OPERATIONS................................. 6 1. P REPARATION 1.1Jack vehicle................................6 1.2 Connecting hose.................................6 .3 Power cables connection...............................7 1.4 Check-up................................... 7 2. F ILLING LIQUID 2.1 Filling detergent................................
ATF as required, the excessive or shortage filling will cause the damage to auto transmission. GT510 auto transmission changer can complete the flush and fluid exchange in 15 minutes for transmission, torque converter and radiator. The fluid exchange rate is nearly 100%.
GT510 ATF System Service Centre 2. Control panel The control panel is shown as in Fig.2. Fig.2 Description: DESCRIPTION ICON NAME LEFT arrow、RIGHT arrow Set parameter、Item select DOWN arrow、UP arrow Item select Parameter confirm, Function ENTER Confirm key execute EXIT Return key、Exit key...
Locate a matched connector inside box and connect it to the disconnected adapter. 2) Connect the two hoses marked “TO TRANSMISSION” of GT510 to the disconnected two ends of the hoses of automatic transmission (no consideration of the fluid flow). Refer to Fig.4.
GT510 ATF System Service Centre .3 Power cables connection Connect the power cables clamps of the unit to the two poles of the vehicle battery. 1.4 Check-up 1) Start the engine, and ensure that there is no leakage in pipeline.
GT510 ATF System Service Centre 4. Adjusting fluid level 4.1 Increase fluid amount When the fluid in transmission is not enough, supply it with the desired amount of fluid. Select adjust function, set the amount of add new fluid, press ENTER button to run.
Maintenance Pay attention to each connection to check if there is any leakage during fluid exchange. When any leak is found, stop the GT510 immediately and check for the unit. Start to exchange fluid again after reconnection is made.