Auto Restart Function - Sharp DF-A1U User Manual

Hide thumbs

Table of Contents

Top tips and hints

For trouble free use of your SHARP Aroma Diffuser, follow

the advice in this user manual and the bullet points below:

• DO NOT block the fan grill as this will cause the mist not to be

emitted correctly.

• Fill the cup to the maximum water level prior to use and

when being used with the Auto Restart function.

• Make sure that the lid is always fitted correctly.

Using your new Aroma Diffuser

Before filling your Aroma Diffuser with water, either turn off via

the

button on the front or disconnect from the mains supply.

Fill the water cup to the maximum mark indicated. Do you not

exceed the maximum mark as this will cause the Aroma diffuser

not to operate correctly and cause spillage of water.

This Aroma Diffuser is designed to be used with clean water,

ideally this should be distilled water or if this is not available

you can use clean tap water. Once the cup has been filled to the

maximum level essential oils can be added to the water. Be sure

to follow the essential oil instructions to ensure that the correct

amount is used.

(Refer to the

2 Water Level Mark on page 1).

Replace the lid, ensuring that it is correctly aligned and fitting

snugly into the base of the unit. If the lid is not installed

correctly there will be a gap between it and the base which will

allow water to drip down the side of the unit. If the lid does not

fit correctly rotate and try again.

(Refer to the

3 Correct Fitment of Lid on page 1).

Once the lid has been correctly fitted, it is possible to turn

on the unit. To do this press the on off

the side. The unit will power up and the LED will be at full

brightness.

button located on

Connecting power to your Aroma Diffuser

Your new SHARP of Aroma Diffuser works with an external AC

adapter. It is important that this AC adapter is kept away from

any water and is not operated or touched if your hands are wet.

Your AC Adaptor plugs into the mains supply and then is

connected to the Aroma Diffuser via the power cable, This

lead has moulded connectors on each end; the USB connector

plugs into the AC Adaptor; the round plug fits into the Aroma

Diffuser.

DO NOT use any other AC adapter or lead with your Aroma

Diffuser as this may cause overheating and potentially

hazardous conditions. DO NOT use USB power extension cables

as these may cause the voltage to drop and result in the Aroma

Diffuser working incorrectly.

(Refer to the

4 Connecting to the AC Adapter on page 2).

When connecting to the AC adapter ensure that the socket and

plug fit securely together before plugging the AC Adaptor into

the mains supply. Loose fitting plugs will cause either erratic or

no operation.

Ensure that the water level is filled to the maximum level before

use; the maximum level is marked clearly inside the cup and

must not be exceeded.