Table of Contents
Advertisement
STANDBY
Switch on the unit. /Put the unit in standby mode.
Note: Being in the standby mode uses a minimal amount of electricity, but ensures that the components
of the unit operate at maximum efficiency from the moment you start.
SOURCE
SELECT
Press repeatedly to select a signal source among DVD, TUNER, LINE 1 and LINE2.
USB
Press this button, use the direction key [ ]/[ ] to select a signal source, DVD, USB or CARD, then
press [ENTER] to access the corresponding mode.
2
3
1
4
5
6
The digit keys can be used to input the corresponding numbers or make selection of a track or a
7
8
9
9
chapter of a disc, etc.
0/10
10+
ENTER
Press to enter an item in the menu or to confirm your operation etc.
The direction keys can be used to move the highlight or adjust the value of an item in the menu .
SETUP
Press to enter/exit the setup menu.
GOTO
During playback, press to enter the GOTO menu. In the menu, use the direction key [ ]/[ ] to select
a setting item and press [ENTER] to enter the editing state, then with the digit keys input a specific
track, disc time, track time, chapter, title, chapter time or title time to go to directly. Press it again to exit
the GOTO menu.
PROGRAM
Press this button to enter/exit the program menu with which you can playback the contents of a disc
in your desired order.
In the program menu, use the direction keys, digits keys and [ENTER] to make a program list, then
move the highlight to START and press [ENTER] to start program playback.
During program playback, press [PROG] to enter the program menu and the STOP is highlighted,
press [ENTER] to cancel program playback.
-17-
Playback
Advertisement
Table of Contents
