Table of Contents
Advertisement
Troubleshooting
No Output
• Check that all your system components are turned on.
• Check that the master power switch adjacent to the AC
receptacle is set to 'Auto On'.
• Check your wires and connections.
• Check all interconnecting cables.
• Make sure the level control is not turned down.
• Turn off and unplug the Dynamo 500 and check the
fuse near the AC power cord receptacle on the back. If
the fuse has blown, replace the bad fuse with a matching
T 1.6A L 250V fuse (T 0.8A L 250V if you are in a
region using 230V).
• If the problem persists, contact your dealer.
Muddy Bass
• Check placement. Try moving the subwoofer closer to
the front and side walls.
• Decrease the level.
• Check your processor setup.
• If the problem persists, contact your dealer.
Hums or Unusual Sounds
• Turn the Dynamo 500 off, unplug all signal inputs, turn
the Dynamo 500 back on and turn up the level. If the
problem disappears, the hum is originating elsewhere
in your system.
• Connect the Dynamo 500's AC connection to the same
AC circuit as the pre amp.
• If the problem persists, contact your dealer.
t
rouBleshootIng
Troubleshooting
13
Hide quick links:
Advertisement
Table of Contents
