2-Channel Mode Using Speaker Level Inputs - MartinLogan Depth I User Manual

2-Channel Mode Using Speaker Level Inputs

This setup is recommended if your subwoofer will be used in
a 2-channel only system with full-range front loudspeakers.
When a signal is connected to the subwoofer's Left In/Right
In subwoofer's Low Pass Filter control is active.
Signal Connection (see figure 10):
1 Connect the left and right outputs of your amplifier to
the subwoofer's high-level Speaker Level In (Left In/Right
In) binding posts. Use quality speaker cable.
If your amplifier only has one set of outputs you may
connect your amplifier to your speakers as normal and
run an additional set of cables from your speakers to the
subwoofer's Speaker Level In binding posts.
It is also possible to connect the left and right outputs
of your amplifier to the left and right speaker level (high
level) inputs of the subwoofer and run an additional set
of cables from your subwoofer to the speakers.
Recommended Control Settings:
1 Set the controls as recommended on page 9.
12 Controls and Connections
Figure 10 . Signal connection for 2-channel mode using speaker level inputs.