Maintenance; When It Is Difficult To Attach The Pad - Omron HV-F128 Instruction Manual

When it is Difficult to Attach the Pad

Wash the Pad when the adhesive surface of Pad becomes dirty and the Pad is difficult to attach.
– Wash the Pads after every thirty uses. Pads can be washed approximately ten times.
– Pads are consumables. Purchase the optional Pad when the adhesive surface is damaged. (Refer to
Page 23.)
❇ The life of Pad may vary by the frequency of wash, skin condition, and storage state.
1. Turn off the power, then remove the Electrode Cord from the Pad.
2. Wash the Pad softly with your fingertips under slow
running water for several seconds.
3. Sufficiently dry the Pad and let the adhesive surface
airdry.
❇ Do not wipe the adhesive surface with a tissue paper or a cloth. If
a tissue paper is adhered to the adhesive surface by accident, do
not try to peel it off. Instead, moisten the tissue paper with a small
amount of water, and then it will come off easily.
4. Lightly attach the Pad to the Electrode Holder for
storage. (Refer to Page 19.)
General advice from OMRON on the handling of Pads
• Do not use hot water, detergent, or chemicals such as thinner or benzine.
• Do not scratch the adhesive surface with your nail or a brush.
• Do not wash the Pad too long or too frequently.
• Do not store the Pad under high temperature, high humidity, and direct sunshine.
❇ The adhesive surface may be damaged and the Pad may last shorter.
❇ If the adhesive surface becomes sticky or the Pad peels off, leave the Pad in the refrigerator (do not freeze)
overnight. The adhesion may be restored.

Maintenance

20